Available in an endless range of colours, durable, and easy to care for, hardwood floor installation is an attractive classic choice that adds tremendous value to a house. Hardwood floors are also easy to repair and refinish unlike many other floor types. Hardwood floors have the ability to look great in any setting, from modern homes to traditional family dwellings. However, many potential buyers may be put off by the cost of installing hardwood floors as well as the fact that hardwood floors require professional installation.
Professional hardwood floor installation can be very expensive, however there are ways to greatly reduce the costs involved. One of the best ways to cut down on the overall costs is to arrange for a plan with a contractor prior to purchasing the floors. With this kind of pre-planning, you can work with the contractor to ensure that all of the floors have been installed to their highest standard and to your specific tastes. You can work with the installer to ensure that all the wood planks have been correctly numbered and installed properly. Learn more about the best hardwood flooring experts.
If you want to cut down on the cost of the floor installation, then you should also consider engineered wood flooring. Engineered wood planks are solid wood planks that are constructed by mixing real and synthetic wood together under high pressure. This provides the floor with the durability of solid wood without the price tag that accompanies it. In addition to this, engineered wood planks have been treated to resist moisture, dirt, and stains. Therefore, your hardwood floor installation will be protected from water damage and rot which can lead to major damage to the flooring. This website has the best hardwood floor installation services, check it out.
Before starting the installation process, the planks will need to be measured. A general rule is that the planks should be no more than 48" wide but no less than 60" wide. If you are using standard nails for the first set of planks, you will need about eight to ten inches of nail head width over each plank. If you use faster-durable fasteners such as screws with nails that are shorter, then you will need only three to four inches of nail head width.
Once the measurements are done, you will need to purchase the flooring material. If you are using solid sub flooring such as hardwood or ceramic tile, then you can count on the retailers to have exactly what you need. However, if you are installing the planks in unfinished subfloor, you may have to go shopping for the flooring yourself. If you are not familiar with installing tiles or hardwood, then you should consult the manufacturers' installation instructions for help. The planks that you buy will be installed using a series of nails which will adhere to the planks to the floor surface. When installing the planks, you should always work from left to right and top to bottom so that the planks will have an even layout.
Before starting the installation process, make sure that the subfloor has been cleared by a professional contractor and that there are no obstacles in the way. The installation of hardwood floors can be quite challenging, especially for the do-it-yourselfer. If you think that you are up to the challenge and would like to install your own hardwood floors, then you should start with a clean room and start from the bottommost board. Work your way to the topmost layer of wood. You should then apply an even layer of wood glue onto the topmost layer of the plank after which you can attach it to the subfloor. Knowledge is power and so you would like to top up what you have learned in this article at https://en.wikipedia.org/wiki/Hardwood.